Assembler I

Summary:

To observe Molding Machines and peripheral equipment for proper operation, inspect components and report any discrepancies to mold setters or supervisor.

Duties and Responsibilities:

• Read and follow Work Instructions, Manufacturing Procedures and Job Instruction Sheets
• Keep area around machines clean
• Label boxes for accepted parts with required work order information
• Visually inspect parts. Place acceptable parts in labeled box. Seal box when correct quantity has been attained
• Place scrap parts in appropriate red scrap bin
• Place sprues/runners into appropriate container
• Notify Supervisor of any recurring defects identified
• Pull correct number of samples per MP or JIS for QA Inspection. Label the bag with the date, machine number, part number, and shift.
• Notify supervisor when leaving workstation
• Ensure that material label on parts container matches the label on the grinder.
• If machine is down, assist other operators or clean work area
• When machine stops notify the appropriate person immediately
• Check one shot from machine hourly to ensure that none of the cavities are blocked and that all cavities are producing acceptable parts.
• Adhere to all Atrion policies including safety, attendance, and personal hygiene requirements per the Atrion Employee Handbook.

Qualifications:

To perform this job successfully, an individual must be able to perform each essential duty satisfactorily. The requirements listed below are representative of the knowledge, skill, and/or ability required. Reasonable accommodations may be made to enable individuals with disabilities to perform the essential functions

• Basic Math skills

• Ability to communicate effectively
• Specific vision abilities required by this job include close vision, color vision, depth perception, and the ability to adjust focus.
• Strong attention to detail and accuracy

Education:

• High School Diploma or GED.
• One to two years of related experience and/or training, or an equivalent combination of education and experience preferred.

Physical Demands:

Up to 1/3 of time is spent walking, stooping, kneeling, and reaching with hands and arms. 2/3 or more of time may be spent standing or sitting. 1/3 to 2/3 of time may be spent lifting up to 25 lbs. 2/3 and more of time may be spent lifting up to 10 lbs.

Work Environment:

The work environment described here is representative of that an employee encounters while performing the essential functions of this job. While performing the duties of this job, the employee will work around electric injection molding machines interacting with others in the same work area. The noise level is typically moderately loud.

PPE:

Hairnet

Beard cover (if needed)

Eye and Hearing Protection as needed for job specific tasks.

Other:

Additional requirements for operators producing CE components